|
|
|
|
|
|
 |
|
Pressed Panels and Plates
|
|
Made of either UD UHMW-PE or UD Aramid or a combination of them.
Vehicle Protection
· FMS production can press up to 1600 x 2500 mm flat panels
· FMS can also produce 3D multi-curved panels in large sizes
· FMS panels can defeat the following international standards:
· NIJ STD. 0108.01
· EN STD. 1063
· STANAG STD. 4569
Personal Protection
· FMS production capacity exceeds 30,000 plates per month
· FMS plates can defeat the following international standards:
· NIJ STD. 0101.04 or 0101.06 Levels IIA, II, IIIA, III and III(+)
· Can be used with a Level IIIA vest or as a stand-alone plates
· Higher threat levels are available upon request
|
| |
|
FMS uses various technologies among them is our proprietary Pre-Cut / Pre-Cut-Pressed technologies
|
| |
|
Pre-Cut Technology
-
Makes available Pre-Cut UD material for vest manufacturers saving cost and waste for the vest manufacturer and to the end-user
-
Pre-Cut technology provides a high-precision cutting of layered UD-materials package, ready for incorporation into the vest coverings
|
|
Pre-Cut-Pressed Technology
-
Makes available Pre-Cut-Pressed UD panels and plates with high cutting precision and excellent press finish
-
Cutting as per customers drawings
-
Sealant of the cutting edges during the process, thus making the panel better water resistant
-
Superior cutting eliminating extra filaments or burns or edge delamination and water absorption caused by after press processing methods
-
Cost savings by reducing waste and by eliminating the need for after press processing
-
Panels are cut to final size and are ready for installation / assembly without further processing required
|
| |
| |
| |
|
|
|
|
|
|
|
